Pulling down bullets is an important part of reloading for reasons such as salvaging components, correcting mistakes, etc. Bullet pulling is needed when you take a fully assembled round and you break it down into your components. If you acquired some ammunition that somebody else reloaded, typically it’s a bad idea to shoot unknown ammo and it could be very dangerous or deadly. To prevent this kind of small issue, xxl reloading will help you to pull bullets without any damage.
In this article, we will demonstrate the top four different ways to break or pull down ammunition into the components. These methods are:
1.Kinetic Puller
A kinetic puller can be pretty cheap but the concept is that you insert your live round into the collet and then you whack this against a hard surface. A kinetic puller works like the concept of Newton’s first law an object in motion tends to stay in motion. However, if you’re using bullets that have a soft tip or there are some with a plastic tip when these fall out of the case and they land in the bottom. It can smash that tip and deform it so you want to be careful. Also, keep in mind that this is a pretty brutal way to pull bullets so while it’s fine for regular ammunition you never want to use anything fancy in it like tracers or spotter or explosive ammunition.
2.Collet Style Puller
A collet-style puller is a die that choice home warranty george foreman threads into your reloading press and you must install the appropriate size to match the caliber you’re working with. The collet is a metal tube with some fingers cut in it that your projectile fits into. If you’re going to be doing a lot of reloading or bullet pulling definitely worth the investment once you buy the die assembly then the only thing you need to buy to do different calibers is the different colleagues.
If you’re going to be pulling bullets that have explosives in them or tracer rounds, things that you don’t want to apply a shock force to like with the kinetic puller. This is a very gentle method so if you’ve got bullets with funny colored tips you want to be careful at all.
3.No Special Tools
This method requires no special tools other than just your reloading press and a pair of hand tools like wire cutters, wire strippers, good pair of pliers, vise grips, etc to grip the bullet with. The idea is to raise the bullet through the top of the press and then you grab it with the tool and once you’ve got a firm grip on it you lower the bullet and it pulls it out. This process works well but it’ll usually damage the projectile rendering it unusable. If that’s the case, you can click here to purchase some new rifle ammunition for you guns.
It works well for lead cast bullets, the soft lead that won’t work in the collet style puller because it’ll just deform and squish up. You can get a nice grip on it with your pliers and pull it out (sometimes bullets can be damaged) but you can just chuck it into your casting pot and melt it down and cast new bullets out of it.
4.Without Tools
If you use a previously fired case as a tool to loosen the bullet and then you pull the bullet by hand. The reason you want a previously fired case is that it will slip over the bullet. However, this can result in deforming the brass but that may be correctable by sizing it. So the idea is you bend it and work it and that should loosen up the bullet and the case doesn’t look too bad. This method has a lot of work and the brass will not be destroyed at all. So that’s another method that you might consider using if you maybe are in the field and you need to pull some down or just have one and you don’t have any other tools to do it with.
Finally, if you’re having trouble pulling your bullet, a lot of bullets have a sealant (one kind of glue) around them to help keep moisture and water out, it’s difficult to pull. So if you put this into your reloading press and you press the bullet down into the case just a hair and then it’ll be much easier to pull the bullet.
